Pros: Simple installation onboard 2.5-inch SSD installation EZ Gig softwareĬons: Comes in a hard-to-open blister pack You can then use the BIOS options available on your PC to make one of the Velocity Solo drives your new boot disk. EZ Gig is disk drive cloning software that will let you, for example, re-create your current boot drive onto your new Velocity Solo SATA 3.0 drive despite any variance in capacity between the source and target drives. The EZ Gig software promised on the blister pack is actually a download from a section of the same website. Should you run into problems, Apricorn maintains an online tech support section at its website. If your drive hasn't already been partitioned or formatted, you'll need to do that through the usual disk management options found in the Control Panel's Administrative Tools icon. Once powered up, your computer should automatically recognize the Velocity Solo and any drives attached to it. Some motherboards maintain a quiescent level of power at the bus.) Pull the power plug and wait a few minutes. (Note to the wise: Whenever you install an interface card or memory module in your PC, don't just shut your computer off. Whether you've used an SSD or a mechanical drive (or both), once the attachments are done, just plug the Velocity Solo into an available x1 PCIe slot, screw it to the backplane, and you're ready to close up your computer and start things up.
(The power connection needs to be brought over from your computer as you normally would with any such installed hard drive - the power directly available from the card is insufficient for a mechanical drive of any size.) If, on the other hand, you've installed a new SATA 3.0 hard drive, you can connect the data port to a connector located at the top rear corner of the Velocity Solo. If you have a 2.5-in.SSD drive, you can mount it directly on the card by sliding it into the SATA data and power connector bank on the Velocity Solo and securing it with the screws provided. There are a couple of ways to connect the Velocity to your drive, depending on the type of drive it is.
0 kommentar(er)
